10
126305 Rev B 05/22/15
Manager’s Mode 12:
To help eliminate paper jams Manager’s Mode 12 will adjust
the length of the receipts. It is highly suggested that the
length of the receipt is configured so that the end of the paper
will exit the chute with the least amount of paper. There is a
“notch” at the end of the paper chute (see figure 3.6). This
“notch” is made to encourage the customer to place their
thumb inside the notch while removing the receipt from the
paper chute.
NOTE:
It is suggested that this mode be configured
after the first receipt is ran. The length of the
receipt will vary, depending on the information
sent from the POS.
Once the module is in Manager’s Mode press the numeric [1]
and [2] key and then press the function [Enter] key.
Once the function [Enter] key is pressed the display will show
the current length of the receipt (see figure 3.7). To lengthen
the receipt enter a number larger than the current count
number. To shorten the receipt enter a number that is lower
than the current number.
As the new count is entered the display will show the new
value (see figure 3.8).
Now that the new setting is being displayed press the function
[Enter] key. Once pressed the previous display will return
with the new current count.
After this is complete press the right Soft Key where “EXIT” is
present on the display to exit Manager’s Mode 12.
If programming is complete press the right Soft Key next to
“EXIT” on the display again and the module will return to
normal operation.
Manager’s Mode 13:
Mode 13 is used to program the payment keypad type.
Once the module is in Manager’s Mode press the numeric [1]
and [3] keys and then press the function [Enter] key.
Once the function [Enter] key is pressed the display will show
the current setting for the keypad. (see figure 3.9).
NOTE: For this unit Option 2 must be programmed.
Programming
(continued...)
Figure 3.6
-
Paper Chute
Paper Chute “notch”
Figure 3.7
-
Manager’s Mode 12
Figure 3.8
-
Resizing the Receipt
Figure 3.9
-
Manager’s Mode 13
