21
126305 Rev B 05/22/15
FIGURE 4.10
-
Tracks are Operational
Service
(continued...)
Manager’s Mode 04:
This mode is used to test the card reader for the module.
Once the module is in Manager’s Mode press the numeric [4]
key and press the function [Enter] key.
Once the module enters into the mode it will send a signal to
the card reader to see if it is acknowledged. At this time the
display will indicate that it is waiting for a response from the
card reader (see figure 4.8).
Once the card reader receives the signal and responds the
display will indicate that the card reader is functioning by
displaying two “^” signals at the end of the top line of the
display (see figure 4.9).
If the module sends the signal to the card reader and it
doesn’t receive a response the display will only show one “^”
signal at the end of the top line of the display. Normally, this
indicates that the card reader was not recognized at power
up or when the unit entered into Manager’s Mode 04.
After the module detects the card reader insert a card to
verify that it is working properly. When the card is slid into
the reader make sure that it has been inserted completely.
At this point remove the card. If the card reader works
properly the display will prompt that the tracks are
operational (see figure 4.10).
If any track fails the display will prompt that there is either no
data on the card tested or there was an error reading the
card (see figure 4.11).
NOTE: To test the card reader make sure that the door
of the unit remains closed. The card
reader
is
very sensitive to light. If the terminal
door
is
open and if the sun is bright enough the
card reader
may not work properly. The Card
Sensor
is
an
optical reader so it may not detect
the card if the sun
is shining on it.
After this is complete press the right Soft Key where “EXIT”
is present on the display to exit Manager’s Mode 04.
If programming is complete press the right Soft Key next to
“EXIT” on the display again and the module will return to
normal operation.
FIGURE 4.8
-
Mode 04
FIGURE 4.9
-
“^^” Card Reader Detected
Card Reader Function
FIGURE 4.11
-
Tracks are In
-
operable
