33
3.
BROWSER BASED PROGRAMMING
3.1 Starting Browser Based Programming
3.1.1 Introduction
On power up, the system is configured with the factory default settings. These
settings can be changed by the installer or system administrator to meet the
individual requirements of the customer using the system's Browser Based
Programming interface.
This section guides the user through the programming options.
Programming is carried out from a PC using any standard Internet Browser, e.g.
Netscape Navigator or Microsoft Internet Explorer, that is connected to the system
either on the Ethernet Port or remotely over an ISDN line.
3.1.2 To Enter Browser Based Programming
To use Browser Based Programming, the system and the PC must be on the same
network with an IP connection established between them. (For details on
configuring the Ethernet connection and the IP addresses, see the safety notices in
section 2.13 of the Installation section).
Open the Internet Browser and type the
IP address of the system followed by the
port number. The default address is -
http://192.168.0.100
The IP address of the system can be
viewed from a systemphone using the
System Maintenance option. (See
Section 3.11).
