17
2.1.2 Equipment
Make sure you have the correct tools:
§
Wall-mounting template
§
2 support screws, 1 fixing screw and rawl plugs (they are in the access area)
§
Drill and chuck-key
§
6mm drill bit
§
Flat head screwdriver
§
Wire stripper
§
Snips and Cable Cleats
§
2M Male-Male RJ45 Line Cord (Not supplied)
2.1.3 Removing the cover
Removal of the access cover exposes the Access Area. This houses the terminals
for the connection of all the devices supported by the Forum 300 System.
To remove the cover:
1. Unscrew the top and bottom screws.
2. Rotate the cover through 90° in the direction shown in next picture.
3. Lift the cover away from the unit.
2.1.4 Wall mounting the unit
Follow the steps below to mount the Forum 300 on the wall. Note that the
mounting screws and rawl plugs are located inside the access area.
1. Mark on the wall the location of the three screw holes using the supplied
template.
2. Drill holes and insert rawl plugs.
3. With the Access Cover removed (see previous section), the supporting and the
fixing screw holes are exposed.
4. Insert the two support screws into the support holes and screw down, leaving
a 5mm clearance from the surface of the wall.
5. Place the keyhole slots of the system over the supporting screws.
6. Insert the remaining screw into the fixing hole, via the access area and screw
down. DO NOT OVER-TIGHTEN as this may damage the plastic housing!
The system is now ready for wiring.
