117
KMX-3921
Installation & Service Manual
To correlate a monitor wall destination in a layout and the corresponding KX Router
logical router
1 In the list on the left-hand screen, touch the
KX Router
logical router associated with the
multiviewer whose name was indicated in the message prompting to select a router
(you can see the multiviewer name, its IP address, and the size of that particular KX
Router).
2 Touch the Video level, in the area to the right of the router list, if it is not selected
already, and then push SELECT.
The RCP-200 will remember the association with the KX Router logical router’s
destinations for the current multiviewer’s monitor wall destinations.
Configuring the Kaleido-RCP2
The Kaleido-RCP2 is a multi-function remote control panel designed for use with Kaleido
multiviewers. Ethernet connectivity allows multiple RCP users to access multiple Kaleido
Multiviewer systems, allowing convenient access to the real-time operating features. When
logged on to a Kaleido multiviewer via its Ethernet connection, the RCP user can control
various operating features.
Before you can use the Kaleido-RCP2 to operate your Kaleido Multiviewer, you must set up
the Ethernet connection between the two devices. By default, the Kaleido-RCP2 is shipped
with DHCP enabled, so it will automatically be assigned an IP address by a DHCP server. If
no DHCP server is present on the network, the Kaleido-RCP2 will default to the static IP
address 10.0.3.191.
Notes
• The
Kaleido-RCP2
is powered through the RJ45 Ethernet connector.
There is no power ON/OFF button, so the device is ON whenever a
powered Ethernet cable is connected.
• If you purchased more than one
Kaleido-RCP2
units, keep in mind that
they all ship with the same default static IP address. Make sure to assign
them different static IP addresses before connecting them to the network
if DHCP is not used. See the
Kaleido-RCP2
User Guide for more
information.
• The time-out period before the
Kaleido-RCP2
defaults to its static address
is 1 minute. To speed up the initialization, disable the DHCP option.
