Belden Grass Valley KMX-3921, Installation & Service Manual

Page: 60 / 156

60
Frame Operation and IP Network Setup
Network Considerations
DEFAULT GW EDIT appears on the control panel’s display.
9 Repeat step 3 to step 5 to configure the gateway.
10 Once you have set the gateway, press the Select button on the front edge of the
KMX-3921 card to exit the control menu.
The card restarts. The startup sequence takes approximately two minutes, during
which time the Status LED is flashing orange. Once the startup has completed, the
Status LED should be green.
11 Check the card’s Status LED, and make sure that it does not indicate an error condition.
See Card Interface and Troubleshooting , on page 52.
12 Verify that the new IP address is effective, by referring to
Finding the Multiviewer’s IP
Address and Application Version , on page 126. Perform this verification for all the cards
that are connected to your system’s rear module.
Network Considerations
TCP/UDP Port Usage
The various KMX-3921 communication protocols require access to specific ports. In
networks where a firewall is present between device A and device B, the ports used to
communicate
from device A to device B must be open on the incoming (external) side of
the firewall.
From client to multiviewer
The following ports must be open on the Client (for example, on the workstation running
XEdit):
Notes
• If you do not touch any button on the Densité 3+ FR4 frame local control
panel, the CPU-ETH2 / CPU-ETH3 controller will revert to its normal
standby mode, and the selected card's Status LED will revert to its normal
operating mode, after 30 seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not touch the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had touched the SEL button.
Note:
All necessary ports are open by default on the multiviewer. There is
no mechanism provided for changing the default settings.
Port Used for Transport Notes
443 HTTPS TCP Used by XAdmin for secure access
7 HTTP TCP Used by XEdit for ping probing
80 TCP Used by XEdit and XAdmin
5122 TCP Used by XEdit for keepalive (heartbeat)