98
System Configuration
Remote Control Using iControl
6 Click
OK
.
The
Apply settings
button becomes available.
7 Click
Apply settings
.
The Kaleido Multiviewer system must be restarted for changes to the network
configuration to take effect. A message appears prompting you to reboot the system
immediately.
8 Click
OK
.
If you have changed the multiviewer’s IP address, you will need to edit the XAdmin URL
in your Web browser's address bar in order to log on to the multiviewer again.
Remote Control Using iControl
The KMX-3921 cards may be controlled by using Grass Valley’s iControl version 7.20 or later.
This section describes the control panels associated with the KMX-3921 cards and their use.
Refer to the iControl User’s Guide for information about setting up and operating iControl.
In iControl Navigator, iControl Web, or iControl Solo, double-click the icon for a KMX-3921
card to open the associated control panel.
KMX-3921 Service Control Panels in iControl
The card label and the modular card slot number where the card is installed in the
Densité 3+ FR1 / Densité 3+ FR4 frame are indicated in the window’s title bar. In the control
panel window, there are three main areas: the status icon area, the navigation area, and the
operating control area.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not reboot after 10 seconds
or so, try clicking
Apply settings
again after a minute or two, until the
multiviewer reboots.
