CHAMELEON® ARCH SERIES
10
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL526
Introduction
Do
’s and Do Not’s
DO
DO NOT
Read all manuals carefully and
completely prior to beginning the
process the manual describes.
DO NOT drill in top of any electrical enclosures.
Verify that all parts needed to perform a step
described in the manual are present prior to
beginning the process.
DO NOT install high voltage and low voltage supply
lines in the same conduit.
Study and understand all installation diagrams and
drawings.
DO NOT power-up controller without following
manual.
Carefully follow all instructions.
DO NOT operate machine without testing all
sensors for clearance and operation.
Use anti-seize lubricant on all threaded fasteners
(screws, bolts, nuts, etc.).
DO NOT operate machine until all safety features
are tested.
Use quality thread sealant on all plumbing
connections to eliminate leaking.
DO NOT service high- or low-pressure
pumps without turning main power off
and
following
Lock-Out/Tag-Out
Procedures. Severe injury could result.
Ask questions when they arise.
DO NOT service without turning main
power off and following Lock-Out/Tag-
Out procedures. Severe injury could
result.
Check all electrical boxes are closed prior to spraying
water.
DO NOT attempt to add components to machine.
Check incoming electrical supply voltage to ensure it
matches equipment order.
DO NOT substitute machine components.
Follow all maintenance schedules to ensure trouble-
free performance.
Periodically check all system stop circuits are
functional.
Table 1
Recommended General Practices to Do and Not Do when Installing, Maintaining, and/or Servicing Belanger® Equipment.
