BayTech LASERSHARE PS-MIO, Owner'S Manual

Page: 61 / 133

NOTE: If you wish to connect a modem to a serial port on the PS-
4C or PS-4E, you must configure the
Virtual setting for the desired
port to be Modem.
If you select [ Configure Port ] from the "Configure Printers" menu
and the highlighted printer in the Printer List is a parallel port on a
PS-4A or PS-4E, the following menu will appear:
Highlight the appropriate parameter and make any desired
change(s) and then select
OK
to install the printer.
NOTE: The parallel ports of the PS-4A and PS-4E are capable of sending
data to the printer at rates in excess of 90K bytes/sec. Some older
printers may lose data at this rate due to the slow response of their busy
lines. If you notice a parallel printer losing data, you may program the
parallel port(s) on the PS-4A or PS-4E to print slower by configuring the
"Line Delay" option in the port configuration menu. Enter a number
between 0 (no delay - default) and 40 in the indicated field. The proper
setting for the printer will require some experimentation. The lowest
setting without incurring data loss should be used. Most parallel printers
will not require any line delay.