BayTech LASERSHARE PS-MIO, Owner'S Manual

Page: 29 / 133

If the factory default parameters are not satisfactory for your
application, you must use the BayTech software utilities to
reconfigure the BayTech print server. If the default parameters are
satisfactory, there is no need to use the BayTech software utilities.
You may use PCONSOLE to add the BayTech print server on the
network and to assign print queues to the ports as described in
Section 6 .
NOTE: Even if the factory default settings are satisfactory, you
may still use the BayTech software utilities to add the BayTech
print server to the network. The primary advantage to using the
BayTech utility is that it automatically informs all selected file
servers the BayTech print server has been added. Otherwise, you
would have to update the desired file servers individually. Other
advantages of the BayTech utility software are described in
Section
7.1
.
CABLING
Section 5.1 discusses the hardware interface to the network and
Section 5.2
explains how to cable your printers or plotters to the
PS-4A, PS-4C, or PS-4E.
CAUTION: Power should be removed anytime cables are installed.
NETWORK INTERFACE
The network port of your BayTech print server is equipped with a
10BASE2 (coax) connector for -CX models, a 10BASE-T (modular)
connector for -TP models, or a DB-9F (STP)/RJ-11 (UTP) connector for -
TR models. The specific network interface type is indicated on the lower
right corner of the back panel. For example,
PS4E-CX
specifies a PS-4E
with a 10BASE2 coax network interface. See
Section 5.1.1
for network
interface instructions for -CX models,
Section 5.1.2
for -TP models, or
Section 5.1.3
for -TR models.