Baroness LM331, Service Manual, Page: 106 / 165

1
4
2
3
un3ioy-002
Proximity Switch (For Reel Cutter Rotation Stop)_002
1 Magnet COMP
2 Lock nut
3 Hollow screw
4 Proximity switch
Proximity switch (for traveling pedal neutral)
Warning
Make sure that there are no people around
the machine.
Important
Make sure that the piston pump of the
machine is set in the neutral condition, before
adjusting the proximity switch.
Important
Adjust the proximity switch after adjusting the
pedal.
Important
Adjust the proximity switch after adjusting the
push-pull cable.
Important
Slide the proximity switch forward and
backward, and adjust it so that the center of
the detection magnet and that of the proximity
switch detection part align when the traveling
pedal is in neutral.
Adjust the proximity switch installed on the
sensor mounting arm by loosening the bolt
and moving it parallel.
In neutral condition, make sure that the
proximity switch detection part and
detection magnet are at the center. 1.
2.
Make sure that the proximity switch does
not move, and tighten the bolt.
When starting the engine, check the
following.
Check that the engine does not start
when moving the engine key to the
"START" position while pressing the
traveling pedal to the forward side.
Check that the engine does not start
when moving the engine key to the
"START" position while pressing the
traveling pedal to the reverse side.
3 2
1
4
A
B
1mux2b-001
Proximity switch (for traveling pedal neutral)_001
1 Proximity switch
2 Proximity switch detection part
3 Detection magnet
4 Bolt
A Front
B Rear
3.
4.
[1]
[2]
LM331
Electrical system
Page 5-32
Adjustment