Barco SilverWriter 800, Field Service Manual

Page: 31 / 276

Field Service Manual December 2003
Page 31 of 276
FLMDOOR eats a value (x=0/1) from TOS.
0 flmdoor = close door
1 flmdoor = open door
•
Syntax: ML
Moves the drum to loadpoint.
•
Syntax: MU
Moves the drum to unloadpoint.
•
Syntax: nnnn ROTA
ROTA eats TOS and stepper motor moves drum over nnnn qenc steps from
index (Absolute)
•
Syntax: nnnn ROTR
ROTR eats TOS and stepper motor moves drum over nnnn qenc steps
(Relative): · in expose direction when TOS is positive.
· in counter expose direction when TOS is negative.
•
Syntax: RPKS .
Pushes drum speed on TOS. Use the . to display TOS.
•
Syntax: MBS
Move bridge sensor.
•
Syntax: MFS
Move film stop.
Optic
•
Syntax:X Y ADCPOT ; X:pot1=0 pot2=1 Y: off=0 on=1
ADCPOT reads TOS. When TOS = 1, the commmand places potentiometer in
feedback loop of I-V convertor onMACCON.
•
Syntax: ALLOFF
Switches all the beams off. This is used to check for the restlight.
•
Syntax: ALLON
Switches all the beams on.
•
Syntax: 2000 4000 LOCKRANGE_ALL
Gives minimum and maximum locking frequency for all the beams. Must be
executed and saved during alignment of the optics. This takes about 90
seconds.
•
Syntax: 12 ON
ON eats a number from TOS and switches this beam number on.
•
Syntax: 12 ONEON
Switches all beams off, except the beam number on TOS.
•
Syntax: RDADC .
RDADC puts a value between 0 and 4095 on TOS. This command is only to
be used when a Photodiode is connected to the 12-bit ADC Current Probe
input connector of the Maccon board.
•
Syntax: 4 2000 SAMP
SAMP eats two numbers from TOS:
· the first number is the beam
· the second number is the amplitude
Set all beams on maximum amplitude:
LTL > 24 do dup 1 – 4095 samp loop
•
Syntax: -1 1 22 GPAR $FFF 1000 SCANK