Rev 14/08/2019 (v3.2)
EN
Bag of Tools:
We have included a small bag with a 5mm hex key and burr shims for
calibration. Installing a shim is only needed if the grind at setting 1 is not
quite fine enough. In our experience, installation of a shim is generally
needed after 1-2 kilos of espresso grinding, but may be needed before that.
Shimming will likely be needed, at some point, based on use.
When needed, installation of just 1 shim is recommended and will shift
the grind finer by about 6 settings. Installing 2 shims at once can shift the
grind range to be so fine that it causes undue stress.
Detailed shimming instructions can be found in the full manual, at the link
on the right.
Still Need Help?
If you have any questions or concerns, please email:
The full manual can be found on our website at:
baratza.com/documentation
For video instructions and troubleshooting guides:
baratza.com/troubleshooting
!
Use only with AC current and the correct voltage.
See the label on the base of the grinder to determine
the correct voltage.
!
Only clean the grinder housing with a dry or slightly damp cloth. Do not
immerse the grinder, plug or cord in water or any other liquid.
!
Baratza will not accept any liability for damage, injury, or warranty if the
grinder is used other than for its intended purpose (i.e. grinding roasted
whole coffee beans) or is improperly operated or repaired.
!
Keep the appliance and its cord out of reach of children aged less than
8 years
!
Do not operate the grinder with a damaged cord or plug. If the supply
cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard
!
Do not leave your grinder unattended while turned ON.
!
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
!
Cleaning and user maintenance shall not be made by children without
supervision.
!
Always unplug the grinder from the electrical supply before assembling,
disassembling or cleaning.
!
To unplug, grasp plug and remove from the outlet. Never pull on the
cord.
SAFETY INFORMATION:
Please read the information below very carefully. It contains important safety information for this appliance.
Please keep these instructions for future reference.
CAUTION: ALWAYS unplug the electrical supply cord prior to cleaning the grinder.
®
QUICK START GUIDE
