Programmable Safety Controller SCR P
186
www.bernstein.eu
- Tel: + 49 571 793 0
Software Code Error
J.1
SCR P
A Two-Hand Control Block can be connected only to an Enabling Device Block (
IN
node), a Safety Output (
IN
node), or
Logic Blocks (excluding Flip-Flop Blocks).
J.3
Only Two-Hand Control inputs or Bypass Blocks with Two-Hand Control inputs connected to them can be connected to the
TC
node
of a Two-Hand Control Block.
K.1
SCR P
A Two-Hand Control input can be connected only to a Two-Hand Control Block (
TC
node), Bypass Block (
IN
node),
Logic Blocks (excluding Flip-Flop Blocks), or an output without an off-delay.
K.2
SCR P:
A Safety Output that has
Safety Output Delay
set to "Off Delay" cannot be directly connected to a Two-Hand Control
Block.
K.3
A Safety Output that has
Safety Output Delay
set to "Off Delay" cannot be connected to a Two-Hand Control Block via an
Enabling Device Block.
L.1
This Safety Output is disabled because a Status Output is using its terminals.
L.2
The
IN
node of a Safety Output cannot be connected to External Device Monitoring, Adjustable Valve Monitor, Mute Sensor
Pair, Bypass Switch, Manual Reset, Mute Enable, or Cancel Off Delay inputs.
L.3
A Safety Output block that has
LR (Latch Reset)
function enabled cannot be connected to Two-Hand Control Blocks or
Enabling Device Blocks.
L.4
A Safety Output block that has
Power up Mode
set to "Manual Reset" cannot be connected to Two-Hand Control Blocks or
Enabling Device Blocks.
12.3 Verifying Driver Installation
1. Click
Start
.
2. Type "Device Manager" in the
Search for programs and files
field at the bottom and click
Device Manager
when Windows locates it.
3. Expand the
Ports (COM & LPT)
dropdown menu.
4. Find
Safety Controller
followed by a COM port number (for example, COM3). It must not have an exclamation
mark, a red ×, or a down arrow on the entry. If you do not have any of these indicators, your device is properly
installed. If any of the indicators appear, follow the instructions after this table to resolve these issues.
1. Expand the
Universal Serial Bus controller
dropdown menu.
2.
Find
SC Programmer A
and
SC Programmer B
. Either one of the entries must not
have an exclamation mark, a red ×, or a down arrow on the entry. If you do not
have any of these indicators, your device is properly installed. If any of the
indicators appear, follow the instructions after this table to resolve these issues
.
Windows 7, 8 and 10
SCR P-PA Drivers
