B&R 5AP92D.1505-I00, User Manual

Page: 45 / 158

Technical data
Automation Panel 9xD - Hygienic design User's manual V 1.80 45
4.1.5 System unit device interfaces
4.1.5.1 System unit PPC2100 (5PPC2100.BYxx-000)
4.1.5.1.1 Overview
1
7
2
8
3 4
9 8 10 9
6
11 12
5
Legend
1 "IF option slot (IF1, IFx)" on page 50 2 Status LEDs of the interface option
1)
3 Interface option - Terminating resistor
1)
4 Screw point for cable shield
5 "CFast slot" on page 48 6 "USB interfaces" on page 47
7 Panel (configuration-dependent) 8 "Ethernet interfaces" on page 46
9 "Power and reset buttons" on page 48 10 "LED status indicators" on page 49
11 "Grounding" on page 46 12 "+24 VDC power supply" on page 45
1) Only available with installed interface option (configuration-dependent, see "IF option slot (IF1, IFx)" on page 50 ).
4.1.5.1.2 +24 VDC power supply
Danger!
The device is only permitted to be supplied with a SELV/PELV power supply or with safety extra-low
voltage (SELV) per EN 60950.
The necessary 3-pin connector is not included in delivery; for suitable accessories, see "0TB103.9x" on page 130 .
The device is protected against overload and reverse polarity by a soldered fuse (10 A, fast-acting). If the fuse
is defective (e.g. due to overload), the device must be sent to B&R for repairs. If the polarity is reversed, it is not
necessary to replace the fuse.
Pin Description Figure
1 +
2 Functional ground
3 -
•
Reverse polarity protection
•
3-pin
•
Male
Electrical properties
Nominal voltage 24 VDC ±25%, SELV
1)
Nominal current Max. 3.5 A
Overvoltage category per EN 61131-2 II
Inrush current Typ. 6 A, max. 10 A for < 300 μs
Galvanic isolation Yes
Uninterruptible power supply No
1) EN 60950 requirements must be observed.