Installation and wiring
100
Automation Panel 9xD - Hygienic design User's manual V 1.80
7. Wiring can now take place. The panel is then installed on the holding hooks of the housing cover. Make sure
the retaining straps are not pinched.
8. Before screwing down the housing cover, make sure that the gasket is lined up with the knobs in the opening
of the panel. The gasket must be flush at the 4 corners and along the respective edges.
9. The housing cover is centered on the panel with 4 screws (2 turns each). Check once more that the gasket
is not pinched.
Swing arm connection
10.Then lightly tighten the remaining Torx M4x12 mm screws. If the housing cover is centered correctly and the
gasket is flush, then all screws can be tightened down (max. torque: 1 Nm).
Swing arm connection
