Technical data
Automation Panel 9xD - Hygienic design User's manual V 1.80
97
4.2.5 Battery compartment
4.2.5.1 5ACCBT01.0000-001
4.2.5.1.1 General information
The lithium battery is needed to retain BIOS CMOS data and to back up the real-time clock (RTC).
The battery is subject to wear and must be replaced if the battery capacity is insufficient (state "Bad").
4.2.5.1.2 Order data
Model number
Short description
Figure
Accessories
5ACCBT01.0000-001
Battery compartment - Dark gray - Includes battery - For
APC2200/PPC2200
Table 31: 5ACCBT01.0000-001 - Order data
For the battery compartment replacement part, see
"5ACCRPC2.0003-000" on page 142
in section "Replacement
parts".
4.2.5.1.3 Technical data
Information:
The following specified characteristic data, features and limit values are only valid for this accessory
and may differ from those of the complete system. The data specified for the complete system applies
to the complete system in which this accessory is installed, for example.
Model number
5ACCBT01.0000-001
General information
Battery
Type
Panasonic 1000 mAh
Nominal voltage
3 V
Service life
8 years
1)
Removable
No
2)
Variant
Lithium
Certifications
CE
Yes
UL
cULus E115267
Industrial control equipment
Operating conditions
Pollution degree per EN 61131-2
Pollution degree 2
Ambient conditions
Temperature
Operation
-25 to 60°C
Storage
-25 to 60°C
Transport
-25 to 60°C
Relative humidity
Operation
5 to 90%
Storage
5 to 95%
Transport
5 to 95%
Mechanical properties
Housing
Material
Dyed gray (similar to Pantone 432C) plastic
Weight
Approx. 13 g
Table 32: 5ACCBT01.0000-001 - Technical data
1)
At 50°C, 6 µA for the components being supplied.
2)
The battery is permanently installed in the battery compartment and cannot be replaced. Always replace the entire battery compartment, see section "Re-
placement parts".
4.2.6 CFast cards
For additional information about compatible CFast cards, see the B&R website (
Collective data sheet CFast cards
).
