B&R 5AP92D.1505-I00, User Manual

Page: 116 / 158

Software
116 Automation Panel 9xD - Hygienic design User's manual V 1.80
7.4.1.6 RFID command set
The transponder reads and writes MIFARE and ISO 15693 tags. The corresponding commands and parameters
are valid depending on the tag being used. When a tag comes within range of the antenna, the PiccSelect message
and serial number of the tag are output. When the tag is removed, the PiccRemove message and serial number
of the tag are output.
**********************************
********* SW_ResetSTART **********
** Mifare **
** B&R Automation **
** S/W Rev. 0.7 **
**ENTER 'helpme' for information**
**********************************
PiccSelect: 3B7CF4E0
PiccRemove: 3B7CF4E0
1. Command "Command syntax"
2. The executed command in plain text
3. Response
read,a,ff ff ff ff ff ff,5
Command "read": Data in block 5 in HEX=00000000000000000000000000000000
"Error: <ErrorNumber> (error syntax)"
There is a difference between operating errors and RFID stack error messages. See section
"Error codes" .
Information:
Each command must be terminated by a carriage return (\r).
7.4.2 Commands
7.4.2.1 General commands
Command Description Parameter 1 Parameter 2 Parameter 3 Parameter 4 Parameter 5
Info_On Outputs command confirmation -- -- -- -- --
Info_Off Does not output command confirmation (default) -- -- -- -- --
Show_Config Displays current settings -- -- -- -- --
Show_Revision Displays software and hardware revision information -- -- -- -- --
Show_Status Displays the RFID stack error -- -- -- -- --
Show_SN Displays the active tag number -- -- -- -- --
Show_Key Displays the active key -- -- -- -- --
Echo_On Displays an input echo for the output -- -- -- -- --
Echo_Off Suppresses the input echo for the output (default) -- -- -- -- --
Startup Displays the startup message -- -- -- -- --
Life Life command -→ Returns OK -- -- -- -- --
Helpme Displays a list of all commands -- -- -- -- --
Show_Error Shows error details -- -- -- -- --
Restart Restarts the reader -- -- -- -- --
Table 33: General commands
7.4.2.2 Upgrade commands
Command Description Parameter 1 Parameter 2 Parameter 3 Parameter 4 Parameter 5
Firmware_Upgrade Switches the transponder reader to USB mass storage
update mode
-- -- -- -- --
Firmware_Info Displays information about the current firmware -- -- -- -- --
Table 34: Update commands
7.4.2.2.1 Upgrade procedure
The following are necessary in order to upgrade the device firmware:
•
Exclusive connection to the USB transponder reader
• Firmware file (e.g. firmware_0.80.bin)
•
Terminal program with active connection to the transponder reader (see "Commissioning" )
•
Direct access to the USB port is an advantage (reconnection).