13 / 46
51376-010 GB/2020-10
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
•
Liquids must not penetrate the inside of the ultrasonic converter or ultrasonic generator.
• Never twist the ultrasonic converter's housing toward the aluminium cylinder (ultrasonic
oscillating system). The ultrasonic oscillating system and its electrical connections would be
damaged as a result.
• Do not operate the device without supervision.
Advice for the medical and laboratory
fi
eld
• The
homogeniser is exclusively intended for use by skilled personnel.
• In isolated cases, unfavourable operating conditions may result in EMC disruptions that may
a
ff
ect devices that are in the direct vicinity.
• During
operation, portable or mobile HF communication systems in the vicinity of the
homogeniser should be turned o
ff
- operation may be disrupted.
Damages
• If damage to the homogeniser is detected, do not connect the ultrasonic homogeniser to the
mains.
• In the event of defects, disconnect the power plug immediately.
•
Repairs must only be conducted by authorised skilled personnel or by the manufacturer.
•
Defective parts must only be replaced with original parts or parts of the same quality!
2 Preparation
Carefully unpack the ultrasonic generator, ultrasonic converter and accessories, and inspect them
for completeness or possible transportation damage. If any damage or defects are found, these
must be immediately noti
fi
ed in writing to the transportation company and to the supplier.
Before startup, the ultrasonic homogeniser is to be left to stand at its operating location for 2 hours
so that it may adapt to the ambient conditions.
Summary of Contents for Sonoplus HD4050
Page 44: ......
