Balluff BIS M-370-000-A02, Manual, Page: 53 / 198

BIS M-62_ MANUAL
46
2
2.6.5 Installing the BIS M-622-070-A01-03-ST33 Profibus (PBS)
Figure 31 - PBS Typical Layouts
The BIS M-622-070-A01-03-ST33
Processor unit is designed for Profibus RFID applications,
where the processor unit is connected as a slave node in a Profibus (DP) network via
compatible cables directly to a Profibus Master (host).
The default Node ID is 63 .
1. Select a suitable location for the BIS M-622_ Processor unit/Antenna.
2. Mount the BIS M-37_ antenna to the BIS M-622_ Processor unit, either directly or
remotely, as described in par. 2.2.
3. Mount the processor unit and antenna to your mounting fixture using M5 (or #10)
diameter screws ( not included ) and secure them with appropriate washers and nuts.
Tighten screws to 1.7 Nm or 15 lbs per inch ± 10% .
4. Attach Profibus-compatible data cables to the 5-pin B-Coded (reverse-keyed), male and
female M12 interface connectors on the BIS M-622_. Connect the other end of the cables
to your Profibus network.
5. Build a power supply cable using the BCC06ZF M12 5-pin female connector. Use
minimum 24 AWG wires for connection to the power supply lines according to the Vdc
connector pinout. Connect the BCC06ZF M12 5-pin female connector to the M12 5-pin
male connector on the processor unit. Connect the other end of the cable (wires or user-
supplied connectors) to the power supply.
6. Apply power to the processor unit after all cable connections have been made. The LEDs
on the unit will flash. The READY LED is ON after the power up sequence has
completed.
to
P
ro
fib
u
s
M
a
st
e
r
B
IS
M
-6
2
2
-0
7
0
_
w a
n
te
n
n
a
PBS IN
BCC06ZF
PBS IN PBS IN PBS IN PBS OUT
BCC06ZF
Profibus
Terminator
Cap
PBS OUT
PBS OUT
to Configuration PC to Configuration PC
to Configuration PC
to Configuration
PC
to Power Supply