Balluff BIS M-370-000-A02, Manual, Page: 120 / 198

DEVICENET INTERFACE
113
8
Figure 61 -
Editing the Controller’s DeviceNet I/O Parameters
The following images display the Input and Output properties tabs (in RSNetWorx for
DeviceNet) for the 1756-DNB/A DeviceNet Bridge / Scanner Module after running the
Scanner Configuration Applet for a second time . The scanner module, in this case, only
identified one node, the Controller, at node address 63. The tabs are used to identify
where input and output data is mapped for each identified node. In the image below,
input data is mapped to start at
1: I.Data(0).0 on the PLC.
6. Run the Scanner Configuration Applet and verify the mapping of the address where the
PLC will write input data for the Controller.
Figure 62 - 1756-DNB/A Input Properties Tab