Balluff BIS M-370-000-A02, Manual, Page: 48 / 198

INSTALLATION
41
2
2.5 INSTALLATION GUIDELINES
2.5.1 Hardware Requirements
The following is a list of minimum components required to create an RFID reading system.
Other components may be required depending on the processor unit model, see the specific
installation procedure for your model.

Host computer with specific interface
(Serial, Subnet16™ or Fieldbus); Programmable
Logic Processor unit (PLC) or PC

RFID processor unit(s) ( BIS M-41x, BIS M-62x or BIS U-62x- Series Processors)

Adequate length cabling, connectors and terminators

Sufficient power capable of powering all the RFID components

Balluff RFID data carrier or labels: BIS M-1xx or BIS U-1xx
2.5.2 Installation Precautions

RF performance and read/write range can be negatively impacted by the proximity of
metallic objects and liquids. Avoid mounting the antenna within 15 cm (6 inches) of
any metallic object or wet surface.

Do not route cables near other unshielded cables or near wiring carrying high voltage
or high current. Cross cables at perpendicular intersections and avoid routing cables
near motors and solenoids.

Avoid mounting the processor unit near sources of EMI (electro-magnetic
interference) or near devices that generate high ESD (electro-static discharge) levels.
Always use adequate ESD prevention measures to dissipate potentially high
voltages.

If electrical interference is encountered (as indicated by a significant reduction in
read/write performance), relocate the processor unit to an area free from potential
sources of interference.