Program Mode
Use the PROGRAM MODE to customize the control to suit a variety of applications by programming
the operating parameters. From the DISPLAY MODE press the PROG key to access the PROGRAM
MODE. To return to the DISPLAY MODE, press the DISP key. Parameters may be programmed in
any operating mode. When a parameter is selected for programming, the keypad display gives you
the following information:
Parameter
Parameter Access:
Value and Units
P = Programmable
V = Factory Preset
L = Locked
All programmable parameters are displayed with a P: in the lower left hand corner of the keypad
display. If a parameter is displayed with a V:, the setting is pre-set at the factory and may be viewed
but not changed while the control is enabled. If the parameter is displayed with an L:, the setting is
locked and the security access code must be entered before any changes can be made.
Control Software Descriptions
The following parameters are available within the Series 23H servo control to allow custom tailoring
the drive for different applications. Detailed programming instructions follow the parameter list.
Level 1 Programming Blocks
Preset Speed Block
Preset Speeds #'s 1-15
- These parameters select the preset speed to be output from the
control when the J1 control terminal strip is wired to use preset speeds with an external control
device. A preset speed only sets an operating speed so a motor direction command is required to
start motor rotation. The range of adjustment is from 0 - MAX OUTPUT SPEED.
Accel/Decel Rate Block
Accel Time #1 and Accel Time #2
- Sets the time in seconds for the output speed of the
control to increase linearly to the RPM specified in the MAX OUTPUT SPEED parameter. The range
of adjustment is from 0 - 3600 seconds from minimum speed to maximum speed with a resolution of
0.1 seconds.
3-6
KEYPAD PROGRAMMING AND OPERATION
PRESET SPEED
# 1
MN723H-10/95 11/28/95 1:11 AM Page 60 (Black plate)
Summary of Contents for 23H Series
