Remote Keypad Mounting
Instructions for Remote Keypad Mounting Using Optional Baldor Keypad Extension
Cable
The keypad assembly (DC00005A-00) comes complete with the screws and gasket required to
mount it to an enclosure. When the keypad is properly mounted to a NEMA Type 4 enclosure, it
retains the Type 4 rating.
Tools Required:
Drill, center punch, tap handle, screwdrivers: Phillips and straight, crescent wrench.
8-32 tap and #29 drill (if threading mounting surface).
1-1/4 standard knockout punch (1-11/16" nominal diameter).
RTV sealant.
(4) 8-32 nuts and lock washers.
Extended 8-32 screws (socket ,phillister) will be required if the mounting surface is thicker than
12 gage and is not tapped (through hole approach).
Remote keypad mounting template. (See next page for template)
Mounting Instructions: For tapped mounting holes
1.
Locate a flat 4" wide x 5.5" minimum high mounting surface. Material should be sufficient
gage (14 minimum).
2.
Place the template provided on the mounting surface or mark the holes as shown on the
template.
3.
Accurately center punch the 4 mounting holes (marked A) and the large knockout (marked B).
4.
Drill the four mounting holes (A) with a #29 bit. Tap an 8-32 thread.
5.
Locate the 1-1/4" knockout center(B) and punch using the manufacturers instructions.
6.
Debur knockout and mounting holes making sure the panel stays clean and flat.
7.
Apply RTV to the 4 holes marked (A).
8.
Assemble the keypad to the panel.
9.
From the inside of the panel, apply RTV over each of the four mounting screws. Cover a 3/4"
area around each screw.
Mounting Instructions: For Clearance mounting holes replace numbered steps above
with the following:
4.
Drill four # 19 clearance holes (A).
8.
Hold the keypad in place on the panel and tighten the (4) 8-32 nuts over a locking washer.
9.
From the inside of the panel, apply RTV over each of the four mounting screws and nuts.
Cover a 3/4" area around each screw while making sure to completely encapsulate the nut
and washer.
2-22 INSTALLATION
MN723H-10/95 11/28/95 1:09 AM Page 34 (Black plate)
Summary of Contents for 23H Series
