Keypad Key Functions
JOG
Used to run the motor at the preprogrammed jog speed. After the jog key has
been pressed, use the FWD or REV keys to run the motor in the direction that
is needed. The JOG key is only active in the LOCAL MODE.
FWD
Used to initiate a forward direction of motor operation. This key is only active in
the LOCAL MODE.
REV
Used to initiate a reverse direction of motor rotation. This key is active only in
the LOCAL MODE.
STOP
Used to command a stop. Depending on the setup of the control, the motor will
either ramp or coast to a stop. This key is operational in all modes of operation
unless it has been disabled by the keypad stop parameter in the Keypad
(programming) Setup Block.
NOTE:
IF THE CONTROL IS OPERATING IN A REMOTE MODE AND THE STOP KEY
IS PRESSED THE CONTROL WILL CHANGE TO THE LOCAL MODE WHEN
THE STOP COMMAND IS INITIATED. TO RESUME OPERATION IN THE
REMOTE MODE, PRESS THE LOCAL KEY.
LOCAL
Push this key to change from REMOTE to LOCAL (keypad) or Local to Remote
operation. When the control is in the LOCAL mode all other external commands
to the J1 terminal strip will be ignored with the exception of the external
trip input.
DISP
DISPLAY MODE. Provides operational status and advances to the next menu
item. When in the PROGRAM MODE the DISP key is used to return to the
DISPLAY MODE.
SHIFT
Used in the PROGRAM MODE and the output speed setting adjustment. The
SHIFT key moves the blinking cursor one digit for each push of the SHIFT key.
While in PROGRAM MODE, the factory preset value may be reset for any
parameter by pressing the SHIFT key until the arrow symbols at the far left of
the keypad display are flashing, and then pressing an ARROW key. In the
DISPLAY MODE the SHIFT key is used to adjust the keypad contrast.
RESET
Used to clear a fault and return to the previous display.
PROG
PROGRAM MODE. While in the PROGRAM MODE the PROG key is used to
edit a parameter setting.
3-2
KEYPAD PROGRAMMING AND OPERATION
MN723H-10/95 11/28/95 1:11 AM Page 56 (Black plate)
Summary of Contents for 23H Series
