Section 3
Keypad Programming and Operation
Using the Keypad
The programming and basic operation of the control is done with simple keystrokes on the keypad
located on the face of the control. The keypad is used to program the control parameters; to
operate the motor when programmed for the KEYPAD ONLY MODE or the local mode when the
control is programmed to operate in one of the remote modes or the SERIAL MODE; and to
monitor the status and outputs of the control by accessing the display options, diagnostic menus
and the fault log.
3-1
KEYPAD PROGRAMMING AND OPERATION
JOG
LOCAL
PROG
FWD
DISP
REV
SHIFT
ENTER
RESET
STOP
Indicator Lights
JOG - Green Lamp lights
when JOG Speed is active.
FWD - Green Lamp lights when
FWD direction is commanded.
REV - Green Lamp lights when
REV direction is commanded.
STOP - Red Lamp lights when
motor STOP is commanded.
Displays control status including
LOCAL or REMOTE operation,
motor direction command, set
value of each parameter/function,
monitoring values such as output
frequency and current, also
displays fault conditions and log.
LCD DISPLAY
JOG
FWD
REV
STOP
LOCAL
DISP
SHIFT
RESET
PROG
UP
ENTER
DOWN
Used to run
preprogrammed
JOG speed.
Used to initiate a
reverse direction run
of the motor.
Used to toggle
between LOCAL
and REMOTE
operation.
Used to take
access the block
programming area.
Used to initiate a
forward direction
run of the motor.
Used to initiate
a motor stop
command.
Depressing this
key changes the
displayed control
status. Also used
to bring the lower
block programming
menu back to the
monitoring menu.
Used to move
the blinking
cursor over
one space for
each push of
the SHIFT key.
Used to initiate a logical
reset after a fault
condition and to take the
block programming menu
up one level.
Used to take
the block
programming
menu down one
level while saving
any changes.
Used to change
the display
parameter or
parameter value
down one increment.
Used to change
the display
parameter or
parameter value
up one increment.
JOG
MN723H-10/95 11/28/95 1:11 AM Page 55 (Black plate)
Summary of Contents for 23H Series
