Balanced Body Allegro 2 Reformer, Assembling Manual

Page: 16 / 164

III. INSTALLING THE EXTENDED LEGS AND POSTS
PARTS LIST
Description Part number Qty.
5/8” screws GEN9942 8
Extended Legs 617-007 4
3/8 flat washers GEN9963 4
3/8 lock washers GEN9962 4
5” Bolts GEN9961 4
Feet for Extended Legs 617-021 4
Carriage posts 617-028 2
7/8” screws GEN9889 4
5/16” Allen wrench TOL1328 1
3/16” Allen wrench GEN9280 1
5/32” Allen wrench GEN9282 1
Note: Kits for extended legs raise the Allegro 2 an additional
6” (15cm) off the ground. Leg kits also come with a U-shaped
storage post for loops that can be installed under the head rest.
See Fig F.
A. INSTALL LEGS
IMPORTANT: INSTALL THE FOOTBAR FIRST!
1. Move the footbar into the vertical position (for stability). Insert
footbar locking pins.
2. If you have a hard floor put a Pilates mat on the floor next to
the Reformer to protect the finish.
3. Grabbing the Reformer frame, roll the Reformer on its side.
4. Using the included 5/32 hex key remove the screws and
washers holding one foot on. Set the screws and washers
aside to install the new foot. Push the spacers out of the
old feet and press into new feet. This may take some effort
and you may want to use something like the handle top of a
screwdriver to help push them in.
5. Install two alignment screws where the foot was. (Figure E)
6. Loosely install the leg with the 5” long bolt, lock washer, and
washer as shown in Figure E.
7. Carefully align the outer edges of the leg with the outer edge
of the frame
8. Tighten the bolt with the wrench provided. Bolt should be very
tight.
9. Attach the new feet.
10. Repeat for other three legs.
15