INTRODUCTION
I-E96-607A
D - 1
APPENDIX D - NIMP01 AND NIMP02 TERMINATION
MODULE CONFIGURATION
INTRODUCTION
The INIIT02 INFI-NET to INFI-NET Transfer Module can use the
NIMP01 or NIMP02 Multi-Function Processor Termination
Module for termination. The NIMP02 termination module is
required only for redundant INFI-NET to INFI-NET interfaces.
Figure
shows the dipshunt configuration required for port
one or two to operate as a data port. Figure
shows the dip-
shunt configuration required for port two to drive a diagnostic
terminal. Figure
shows the jumper assignments for hand-
shake signals. These jumpers are normally installed. Figure
shows the required jumper settings for J14 through J17.
Figure
shows the required jumper setting for J18. Figure
shows the NIMP01 connector assignments and jumper
locations. Figure
shows NIMP01 termination module cable
connections. Refer to
for cable diagrams and infor-
mation on how to install redundant termination modules.
Figure D-1. Jumper Configuration for Data Port
(Port 1 or 2)
RXD
RXD-A
TXD-A
TXD
CTS-A
CTS
RTS-A
RTS
DB25-3
DB25-2
DB25-4
DB25-5
J1 AND J2
1
2
3
4
5
6
7
8
9
10
11
12
T00233A
