INSTALLATION
INSTALLING THE PROCESS HARDWARE
3 - 2
I-E96-315B
®
INSTALLING THE PROCESS HARDWARE
To install the throttle valve, hydraulic actuator, servo valve and
LVDT:
1. Follow the manufacturers' directions and recommenda-
tions for installation.
2. Use the size and type of cabling the manufacturer recom-
mends.
INSTALLING THE TERMINATION UNIT OR MODULE
For information about installing process wiring and the digital
input termination unit (TDI) or digital input termination mod-
ule (IDI), refer to the TDI or IDI termination instruction.
and
contain a quick reference of termi-
nation unit/module information. To install the termination
unit or module and field wiring:
Termination Unit Installation
1. Configure the dipshunts on the termination unit.
2. Install the termination unit on the termination unit panel
and secure into place with two screws.
3. Connect the wiring from the servo valve, linear variable dif-
ferential transformer and digital I/O to the termination unit.
4. Connect the hooded end of the NKTU01/12 cable to the
rear of the module mounting unit (MMU) slot for the HSS. Con-
nect the other end of the cable to the P1 connector on the ter-
mination unit.
5. If digital I/O is system powered, wire the I/O common to
the DC common bus bar at the bottom of the cabinet using a
14 AWG wire.
CAUTION
Only qualified personnel should install the throttle valve,
hydraulic actuator, servo valve and linear variable differential
transformer. Improper installation can cause damage to plant
equipment, reduce plant performance and compromise the
safety of plant personnel.
ATTENTION
Seul le personnel qualifie doit installer la soupape modulatrice,
l'actionneur hydraulique, la soupape de pilotage et le transfor-
mateur lineaire a differentiel variable. Une installation inade-
quate pourrait endommager l'equipement en chantier, reduire
les performances de l'usine et mettre en jeu la securite du per-
sonnel.
