Baby Lock Destiny BLDY, Instruction And Reference Manual

Page: 188 / 225

TROUBLESHOOTING
381
A
ppe
ndi
x
9
If the machine stops operating correctly, check the following possible problems before requesting service.
You can solve most problems by yourself. Visit us at “ www.babylock.com ”.
If the problem persists, contact your Baby Lock retailer.
Frequent Troubleshooting Topics
Detailed causes and remedies for common troubleshooting topics are described below. Be sure to refer to
this before contacting your Baby Lock retailer.
Upper Thread is Too Tight
■
Symptom
* The upper thread appears as a single continuous
line.
* The lower thread is visible from the upper side of the
fabric. (Refer to the illustration below.)
* The upper thread has tightened up, and comes out
when pulled.
* The upper thread has tightened up, and wrinkles
appear in the fabric.
* The upper thread tension is tight, and the results do
not change even after the thread tension is adjusted.
a Lower side of fabric
b
Lower thread visible from upper side of fabric
c
Upper thread
d Upper side of fabric
e
Lower thread
■
Cause
Incorrect lower threading
If the lower thread is incorrectly threaded, instead of
the appropriate tension being applied to the lower
thread, it is pulled through the fabric when the
upper thread is pulled up. For this reason, the thread
is visible from the upper side of the fabric.
■
Remedy
Correctly install the lower thread.
a
Turn off the sewing machine.
b
Remove the bobbin from the bobbin case.
c
Place the bobbin in the bobbin case so that
the thread unwinds in the correct direction.
* Hold the bobbin with your right hand with the
thread unwinding to the left, and hold the end of the
thread with your left hand. Then, with your right
hand, place the bobbin in the bobbin case.
If the bobbin is inserted with the thread unwinding
in the wrong direction, sewing will be done with
an incorrect thread tension.
TROUBLESHOOTING
■
Upper Thread is Too Tight
page 381
■
Tangled Thread on Wrong Side of Fabric
page 382
■
Incorrect Thread Tension
page 384
■
Fabric is Caught in the Machine and Cannot be
Removed
page 385