Baby Lock Destiny BLDY, Instruction And Reference Manual

Page: 175 / 225

CREATING BOBBIN WORK (EMBROIDERY)
368
Selecting the Pattern
a
Attach the embroidery foot “W+” or “W”
and the embroidery unit.
b
Install a bobbin wound with an adequate
amount of thread for pattern.
c
Pull up the bobbin thread above the needle
plate.
d
Turn on the machine.
e
Press .
→
The carriage will move to the initialization position.
f
To select a bobbin work embroidery
pattern, press (Embroidery).
g
Press for bobbin work patterns.
h
Select one of the bobbin work embroidery
patterns.
Embroidery patterns for bobbin work appear with
the letter “B” in the lower-left corner of the key.
a
“B” mark
→
Regardless of the setting that had been selected, the
automatic thread cutting function is turned off.
→
When a bobbin work embroidery pattern is selected
the embroidery sewing speed is automatically set at
350 spm.
CREATING BOBBIN WORK (EMBROIDERY)
Note
• Prepare the machine for bobbin work as
described in “PREPARING FOR BOBBIN
WORK” on page 359.
Note
• For an estimated length of bobbin thread
required for each pattern, refer to the Quick
Reference Guide included with the
machine. Be sure to use a bobbin wound
with enough thread. If the bobbin runs out
of thread while sewing, the embroidery
cannot be completed.
• Depending on the thread thickness, it may
not be possible to wind the bobbin with the
necessary length of thread. In this case, try
winding the bobbin again, or use a lighter
weight thread.
Note
• The beginning and end of stitching are
specified for bobbin work patterns. They
cannot be used for normal embroidering.
CAUTION
• When sewing bobbin work, be sure to select an
embroidery pattern for bobbin work. If any other
type of pattern is selected, the machine may be
damaged.
Note
• Embroidery sewing speed defaults to 350
spm when a bobbin work embroidery
pattern is selected. The Settings screen will
not allow speed to be adjusted.
a