ERROR MESSAGES
186
■
Alarm Sounds
If the operation was performed incorrectly, an alarm sounds to indicate that an error occurred. If the operation was performed
correctly, the machine beeps to confirm the operation.
56
Use the presser foot lifter button to lower the
presser foot.
This message is displayed when a button, such as the “Start/Stop” button, is
pushed while the presser foot is raised.
57
Use the presser foot lifter button to raise the presser
foot.
This message is displayed when the embroidery unit is attached and the
power is turned on with the needle in the down position.
58
When the speed controller is set to control the
zigzag stitch width, the "Start/Stop" button does
not operate.
This message is displayed when the speed control lever is set to control the
zigzag stitch width, and the “Start/ Stop” button is pushed. Use the foot
controller to operate the machine.
Memo
• To cancel the operation beep or to change the volume, press
and then change the setting for [Machine
Speaker Volume]. Refer to page 28 for more details.
Error messages
Cause/solution
Summary of Contents for BLTA
