UMAX180800, 20 Thermocouple, 2 RTD, 4 Inputs, 6 Relays Dual CAN Controller
Version 1
Page: 42-71
Upon connection, EA will show the controller on the list of ECUs that are present on the J1939
CAN network. If the controller is the only one ECU on the network, the following screen will
appear, see Figure 11.
Figure 11. 20 Thermocouple, 2 RTD, 4 Inputs, 6 Relays Dual CAN Controller with SAE J1939 and Ethernet in EA
The user can then browse through the ECU parameters, read
General ECU Information
and
Bootloader Information
groups, view and modify configuration parameters, see Figure 12.
The configuration parameters are grouped into function blocks. Please, refer to the appropriate
section of this manual describing the required function block.
In the
General ECU Information
group, the user will see the version number of the application
firmware. Please, make sure that the user manual version number matches with the most
significant part of the application firmware version number. Otherwise, a different user manual
is required to work with this controller.
Figure 12. General ECU Information Screen
4.3 Function blocks in EA
Many setpoints have been reference throughout this manual. This section describes in detail
each setpoint, their defaults and ranges. For more information on how each setpoint is used by
the ECU, refer to the relevant section of the User Manual.
4.3.1 J1939 Network Setpoints
