
36
3 Driver Software Installation – Novell NetWare
9.
Enter the interrupt and I/O address values for the
appropriate PC interface card.
The first PC interface card installed uses the I/O
address 150.
10. Press Esc twice and save the configuration changes.
11. Press Esc to return to the “Internetworking Configu-
ration” menu.
12. Select the item “Reinitialize system” to activate the
new configuration.
The CAPI interface is now available in the system.
3.3.2.2 Installing Additional ISDN-Controllers
If you want to operate several AVM ISDN-Controller
T1s/T1-Bs in one computer, you must first assign each
PC interface card a unique card number. See the instruc-
tions in Chapter 2, “Hardware Installation”.
To install additional AVM ISDN-Controller T1s/T1-Bs,
perform steps 1 to 11 of the procedure in the preceding
section 3.3.2.1, “Configuring the ISDN-Controller”.
3.3.2.3 Removing the ISDN-Controller
To undo the installation of the AVM ISDN-Controllers
T1/T1-B in Novell NetWare 3.x or 4.x, proceed as follows:
1.
At the system console, type
load inetcfg
and press Return.
2.
In the “Internetworking Configuration” menu that ap-
pears, select the item “Boards” and press Return.
3.
In the list of installed adapters, select the AVM ISDN-
Controller T1/T1-B that you want to remove from
the system, and press Del (the Delete key). Select
Yes to confirm the action.
4.
Press Esc to close the menus and INETCFG.