
20
3 Driver Software Installation
–
MS-DOS
Before you begin the installation, make sure the PC
interface card(s) have been correctly installed in the
computer. Make sure too that the I/O address 150 is not
used by any other adapters in the PC. This is the default
value used by the first PC interface card installed. If you
want to operate several AVM ISDN-Controller T1s/
T1-Bs in one computer, you must first assign each PC
interface card a unique card number. See the instructions
in Chapter 2, “Hardware Installation”.
3.1.1 Installing the Driver Software
To install the driver software, proceed as follows:
1.
Insert the original disk labeled “AVM ISDN-Controller
T1, Installation DOS” in your floppy disk drive.
2.
Change the current directory to your floppy disk drive
and then enter
install <Return>
to start the installation program. The installation
program’s sign-on screen appears. You can abort the
installation at any time by selecting EXIT or by
pressing Ctrl+X. To proceed with the installation,
press Return.
3.
Select the D-channel protocol used by your ISDN line
(DSS1 or 1TR6).
Use the Tab key to select the desired entry, then
confirm by pressing Return.
4.
A list of available drives appears. Choose the drive on
which the driver software is to be installed.
Use the arrow keys to browse in the list and confirm
your choice by pressing Return.
5.
Next, choose the subdirectory where you want to
install the controller software.
The default is \IDRIVER, but this can be changed to any
name you wish. Confirm again by pressing Return.