
25
3 Driver Software Installation – Windows NT
in DOS windows are not supported, however). See Appen-
dix A for further information about CAPI.
Before you begin the installation, make sure the PC
interface card(s) have been correctly installed in the
computer. Make sure too that the I/O address 150 is not
used by any other adapters in the PC. This is the default
value used by the first PC interface card installed. If you
want to operate several AVM ISDN-Controller T1s/
T1-Bs in one computer, you must first assign each PC
interface card a unique card number. See the instructions
in Chapter 2, “Hardware Installation”.
3.2.1 Installing the Driver Software
To install the driver software, proceed as follows:
1.
Start Windows NT.
2.
Insert the original disk labeled “AVM ISDN-Controller
T1, Installation Windows NT” in your floppy disk drive.
3.
Select the “Run” command in the Windows NT 4.0
Start menu (Windows NT 3.51: select the “Run”
command in the “File” menu of the Program Man-
ager). In the command line, enter
a:setup
and confirm by clicking on OK.
4.
The Setup program’s sign-on message appears. Click
on Continue.
The installation can be canceled at any time by
selecting Exit.
5.
A list of installed ISDN-Controllers is then displayed. If
no AVM ISDN-Controllers are installed yet, the entry
“New” (Add an ISDN-Controller) is selected for you.
Click on Continue.
6.
Enter the name of the directory in which you want to
install the ISDN-Controller software.