
29
3 Driver Software Installation – Novell NetWare
3.3 Novell NetWare 3.x and 4.x Installation
Two installation variants are supplied for Novell NetWare
3.x and 4.x: stand-alone CAPI and CAPI Manager. The
different installation and configuration procedures are
described below.
Before you begin the installation, make sure the PC
interface card(s) have been correctly installed in the
computer. Make sure too that the I/O address 150 is not
used by any other adapters in the PC. This is the default
value used by the first PC interface card installed. If you
want to operate several AVM ISDN-Controller T1s/T1-
Bs in one computer, you must first assign each PC
interface card a unique card number. See the instructions
in Chapter 2, “Hardware Installation”.
3.3.1 Installing the Driver Software as a Stand-
Alone CAPI
To install the driver software, proceed as follows:
1.
Insert the original disk labeled “AVM ISDN-Controller
T1, Installation CAPI” in your floppy disk drive.
2.
At the DOS prompt, change the current directory to
\DOS on this floppy disk, and enter the command:
install <Return>
The installation program creates a directory on drive
C: named \T1INIT which contains the initialization
program for the PC interface card and a batch routine
to start this program. A command sequence to call
this batch file is added to the AUTOEXEC.BAT file:
call cd \t1init
call t1init
call cd \
The previous version of AUTOEXEC.BAT is saved as
AUTOEXEC.T1.