03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
14
Adjustment
1. Set the position of the oscillator disc as
described in the section "Oscillator disc,
toothed wheel".
2. Secure the cutter in a bench vice (fig. 1).
3. Bring the circular cutter into the illustrated
position (fig. 1) by turning the toothed
wheel (1).
4. Clap up the bottom cutter onto the circular
cutter (fig. 2).
5. Press the bottom cutter onto the circular
cutter and at the same time tighten the
fastening screws on the square axle. In
order to push in the bottom cutter, gently
turn the square axle by several degrees
(approx. 5) using a fork spanner (fig. 2).
WARNING!
Danger of injury! There is a risk of
cutting oneself while carrying out
service work on the cutter!
«
Only grasp the toothed wheel to
turn the circular cutter!.
1
2