03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
10
Servicing the cutter
General notes
«
Before taking the following steps remove
the entire cutter unit (fig. 1), including the
plug connectors, from the device.
Cutter motor
Almost all service work initially requires dis-
mantling of the cutter motor (1) including
the cutter motor cover (2), as described
below.
Tools
•
Phillips screwdriver, small
•
Allan key 3mm
Disassembling/assembly
1. Remove the two Phillips screws (3) on the
cutter motor cover. Remove the cover.
¯
Do not lose the sleeve (4) when you pull
out the screw!
2. Detach the connector cable from the
motor.
3. Unscrew the four screws (5) on the motor
flange. Remove the motor.
WARNING!
Danger of injury! There is a risk of
being cut while carrying out service
work on the cutter!
«
Avoid touching the cutter blades.
«
Handle the cutter very cautious.
1
2
3
