03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
12
Oscillator Disc, Toothed Wheel
The oscillator disc (1) and toothed
wheel (2) both sit on the motor end of the
circular cutter (fig. 1).
Tool
Allan key 3 mm
Disassembling/assembly
1. Remove the motor cover, motor, toothed
belt and photoelectric switch.
P
For more detailed information, see the
sections "Cutter motor", "Toothed belt" and
"Photoelectric switch".
2. Unscrew the Allan key screw (3).
3. Remove the oscillator disc and toothed
wheel (fig. 2).
Setting the oscillator disc
1. Turn the toothed wheel (fig. 3, white arrow)
in a clockwise direction until a gap of
approx. 1.5 mm remains between the stop
tab (4, figs. 2 and 3) of the cutter casing
and the toothed wheel groove (fig. 3).
2. Loosen the screw (3). Turn the oscillator
disc (fig. 3, black arrow) until the short
recess (5) in the oscillator disc is
positioned in front of the photoelectric
switch (6).
3. Tighten the screw (3).
2
1
3
1,5 mm