![background image](http://html1.mh-extra.com/html/avery-dennison/cutter-2000/cutter-2000_technical-manual_3030526006.webp)
03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
6
4. Attach the adjustment plate (5) by
unscrewing the top left hexagonal screw
(6) on the print or draw unit, place the
adjustment plate underneath, and then
tighten the screw again - initially only
lightly (fig. 4).
¯
The square axle of the cutter unit must
rest in the square recess of the adjustment
plate.(fig. 4)
¯
AP 5.4/5.6 only:
The adjustment plate differs from the
64-xx/TTX 350/TTX version. It is provided
with every AP 5.4/5.6 printer (fixed on the
printer bottom with adhesive tape).
5. If necessary, position the adjustment
plate (4) with the help of the hex screw (6)
so that the cut image and print image are
lying parallel (fig. 5).
6. Tighten all three fastening screws.
7. Plug the knife motor cable into the socket
on the front of the printer (fig. 6).
Function check for AP 5.4 / AP 5.6 /
AP 7.t
For testing purposes can be triggered a cut
by calling parameter
SERVICE FUNCTION >
Cutter Test
. This way, the cutter function can
be tested without changing the printer peri-
pheral setting.
CAUTION! - Under no circumstances
should the plug be attached or re-
moved when the device is switched
on, as otherwise the device electron-
ics could be damaged.
4
5
6