INSTALLATION INSTRUCTIONS
NISSAN ALTIMA 1993 – 97, SENTRA 1995 – 1999, 200SX 1995 – 1999
1303/
1315
HARDWARE KIT
TOOLS REQUIRED
5 – Plastic Expansion Plugs
1 – Phillips Screwdriver
5 – #6 x ½” Pan Head Sheet Metal Screws
1 – Pair Side Cutters
4 – Large Bumpons
2 – 3M Anti-Abrasion Film Pads
2 – Black ‘E’ clips – See supplemental instruction “Installing Black ‘E’ Clips onto Deflector”
INSTALLATION
1.
Be sure that the hood is clean and dry inside and out.
2.
Center the deflector on the hood, determine where the deflector will mount, remove and discard the corresponding hood
seal clips.
3.
Slide the deflector in between the hood and the hood seal.
4.
Insert the expansion plugs through the existing holes in the hood seal, where the clips were removed in step 2, through
the deflector and into the hood.
See Figure #1.
Ensure that all the components are well seated against the hood, then
insert and tighten the screws into the expansion plugs.
5.
Install the bumpons on the hood as shown in Figure #2.
Attention: The bumpons must be installed on the hood not
on the deflector!!!
If the bumpons are installed on the deflector they will wear through the paint.
6.
Install the anti-abrasion film pad directly under where the ‘E’ clips will fit on the hood. Be sure to wrap the pads over the
leading edge of the hood and fold over to cover at least ½" of the bottom of the hood.
7.
Install the ‘E’ clips by gently pulling the deflector wings towards the leading edge of the hood until they slide over and clip
onto the hood edge.
8.
On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the deflector when opening or closing the hood.
CARE INSTRUCTIONS
Clean the deflector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents.
Periodically check to make sure the bumpons are in place and the deflector is secure.
Avoid using automatic car
washes.
Do not pull on the deflector when opening or closing the hood.
FIGURE #1. FASTENER ASSEMBLY
FIGURE #2. BUMPON LOCATION
Thank you for purchasing a
form fit
hood deflector.
Retain this sheet for care instructions and kit information.
Rev5.070911
