Operation Mode
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 32
3.9 How to View Detailed Zonal Information
Note that the optional alarm presentation with zonal indication is
used throughout the handbook
. The default alarm presentation
provides both zonal and point information.
To be able to select among zones in alarm, fault or test state, you
simply press the ENTER button. You can now use the up/down arrow
buttons to select the wanted zone (in this example
Fire Alarms
).
To view
detailed zonal information
for the zone you have selected
(highlighted), you simply press the ENTER button once more. The
following screen picture will appear (example):
Detailed zonal information will be available. In the
example
above you
can view the zone in alarm, the first point in fire alarm, the time
entering alarm, the activation state of outputs, what triggered the
alarm (for example, Manual Call-point operation) and the activation
time. You can also move directly to SHOW POINTS (press digit 1).
The Close Window button is used to go one step backwards (at any
time).
FIRE ALARMS
19:23
Total: 3
1 OFFICES
2 CANTEEN
3 WORKSHOP
1: SHOW POINTS
19:23
Total: 3
FIRE ALARM INFO
19:23
Total: 3
ZONE IN ALARM
OFFICES
FIRST POINT/MCP IN FIRE ALARM:
P6 Manual
TIME ENTERING ALARM: 19:07
OUTPUTS
: Activated
ACTIVATED BY
: McpOperation
ACTIVATION TIME
: 19:07
FIRE ALARMS Total: 3
3 WORKSHOP
Last
zone
in alarm
Total
number
of zones
in alarm
First
point
The
activation
time
The point
type
The time
entering
alarm
Zone in
Alarm
Activated
by
1: SHOW POINTS
Outputs
activated
(or not)
NOTE: If you have entered SHOW STATUS for more detailed point information, you
have to press the Close Window button to re-enter Operation Mode in order to activate
the Silence Alarms button and the Reset button.
