Operation Mode
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 26
3. Operation Mode
3.1 Introduction
The operator panel can be in either
Operation Mode
or
Menu Mode.
When no one is operating the panel and no button has been pressed,
the panel will always be in
Operation Mode
.
The display may look as follows in the panel’s idle state.
Note that an alarm, a disablement, test or fault will
always
be indicated
on the display when such events occur.
It is possible to enter
Operation Mode
in two different ways.
initial mode (start up) - idle state
when pressing the menu button in Menu Mode, which will leave
menu mode from all menu levels
AUTROSAFE
SelfVerify
19:23
Total: 3
NOTE:
All events that may occur are presented in Operation Mode.
All handling of events, i.e. Silence Alarms, Accept and
System Reset takes place in Operation Mode.
