Autonics LP-A Series, User Manual

Page: 63 / 106

5 System Setting Menu
© Copyright Reserved Autonics Co., Ltd. 63
5.3.5.7 Touch Calibration
Calibrate the touch point location.
Touch the 'start touch calibration' button at the center of the screen to display a small white +
point.
+ Press until the point moves to the next position, calibrating the total of 9 points.
When the calibration is complete, the 'Save' and 'Close' buttons will appear.
Touch 'Save' to save and complete touch calibration, or 'Close' to complete without saving
calibration.
5.3.5.8 Battery
Check the battery remaining.
The LP’s battery is used for user set-up status, data backup in the latch area, and time-keeping
in case of sudden power failure or other power failure.
Replace the battery periodically to make sure that it does not exceed 5%.
For detailed information about battery replacement, please refer to ‘7.1 Battery Replacement’.
5.3.5.9 System Information
Check system information and disk capacity of LP device.

System information
Item Description
Device name
Shows the device name of LP. This can be modified by touching ‘Change’
button.
Model name Shows the model name of LP.
Firmware
version
Shows the current firmware version of LP.
Release date Shows the date the firmware was released.
 Disk capacity
Project, GP internal storage device, USB memory, Micro SD (LP-A104) can be checked.
Remaining space and total space are displayed only when external memory (USB, Micro
SD) is inserted. Clicking the Remove External Memory button disables the external memory.
5.3.5.10 Initialize
Delete the project saved in the LP device.
Touching the Factory reset menu will show a screen asking whether the system is initialized.
Touching 'Confirm' will lead to initialization, and it will be rebooted after completion.
Do not turn off power while the system is initialized.
Free Space
Total Size
External
Memory Remove