Do-more H2 Series PLC Hardware User Manual, 1st Edition, Rev. F - H2-DM-M
1–11
Chapter 1: Getting Started
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
Step 3: Install Hardware
The “Installation and Wiring” chapter of this manual contains detailed information for the
installation of components in your Do-more! PLC system. The following summary explains
the basic steps for installing modules in a base.
First slide the module retaining clips to the out position and align the PC board(s) of the
module with the grooves on the top and bottom of the base. Push the module straight into the
base until it is firmly seated in the backplane connector. Once the module is inserted into the
base, push in the retaining clips to firmly secure the module to the base.
WARNING: Minimize the risk of electrical shock, personal injury, or equipment damage. Always
disconnect the system power before installing or removing any system component.
Once all of the modules have been
installed in the base, connect the USB
cable. Use a standard USB cable with
Type A and Type B connectors.
(Ethernet and Serial connections are
also available, but are not shown for
this example.)
RS-232
SERIAL
USB
PGM
PORT
RUN
TERM
STOP
1
0
/
1
0
0
E
T
H
E
R
N
E
T
R
R
R
R
RS
S-
S
S
S
S
S
S
S
E
R
U
U
P
P
P
O
TERM
TERM
TERM
1
0
1
0
/
1
0
/
1
0
/
0
1
0
0
1
0
0
1
0
0
1
0
0
0
0
E
T
H
E
T
H
E
R
N
E
R
N
E
T
E
T
H2-DM1E
Type A
H2-DM1E
RS-232
SERIAL
USB
PGM
PORT
RUN
TERM
STOP
1
0
/
1
0
0
E
T
H
E
R
N
E
T
Type
B
Align module PC board to slots
in base and slide in
Push the retaining clips in to
secure the module to the base
CPU must be positioned in the
first slot of the base