Do-more H2 Series PLC User Manual, 1st Edition, Rev. F - H2-DM-M
6–38
Chapter 6: Specifications - Analog I/O Modules
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
F2-02DAS-2, Analog Output - continued
Setting the Module Jumpers
The F2-02DAS-2 Analog Output module uses jumpers for selecting the voltage range for each
channel. The range of each channel can be independently set. The available operating ranges
are 0–5 V and 0–10 V.
There is one jumper for each channel. Install or remove these jumpers to select the desired
range. See the figures below to find the jumpers on your module. The module is set from
the factory for the 0–5 V range. Refer to the following table in order to configure module
differently. Unused jumpers can be stored on a single post to prevent losing them.
NOTE:
It is important to set the module jumpers correctly. The module will not operate correctly if the
jumpers are not properly set for the desired voltage range.
F2-02DAS-2 Module Jumper Table
Voltage Range
0-5V/0-10V Jumper
0 to 5V
Yes
0 to 10V
No
Yes = Jumper Installed
No = Jumper Removed
CH1
CH2
Jumper
ON
= 0-5V
OFF
= 0-10V
J1
J2
CH1
CH2
Jumper
ON
= 0-5V
OFF
= 0-10V
J7
J8
