User's Manual
49
February 2007
MP-202 Telephone Adapter
5. Configuring VoIP Parameters
Table
5-12: VoIP - Services
Parameter
Description
Call Waiting
Call Waiting SIP Reply - which response message is sent when another call
arrives while a call is in progress. There are two possibilities: 180 Ringing
or 182 Queued (default). To disable the call waiting feature, select 180
Ringing.
Call Forward Type
The Call Forward feature permits a user to redirect incoming calls
addressed to him/her to another number. The user’s ability to originate calls
is unaffected by Call Forward. Three types of Call Forwarding exist:
Unconditional. When selected, incoming calls are forwarded
independently of the status of the endpoint.
Busy. When selected, incoming calls are forwarded only if the endpoint
is busy, i.e., if all lines are active.
No Reply. When selected, incoming calls are forwarded only if the
endpoint does not answer before a pre-configured timeout (see next
parameter).
Time for No Reply
Forward
If you specify 5 seconds for this parameter, for example, and 'No Reply' is
selected for parameter 'Call Forward Type' (see above), incoming calls are
forwarded only after 5 seconds lapse.
Key Sequence
The default is *72 but users can modify to any sequence of up to 2 digits,
i.e., *n or *nm.
Message Waiting
Indication
Subscribe to MWI
Check this checkbox if you must register with a MWI subscriber server. If
so, configure the three parameters below.
MWI Server IP Address
or Host Name
The IP address or host name of the MWI server.
MWI Server Port
The port number of the MWI server.
MWI Subscribe
Expiration TIme
The interval between registrations.
Stutter Tone Duration
When you enable message waiting and an unheard message exists, you'll
hear a stutter tone for the duration configured in this parameter and/or
when you activate the call forwarding feature (refer to 'Forwarding Calls to
Another Phone' on page
59
).