Version 6.6
525
October 2014
Installation & Operation Manual
38. Configuring the PSTN Subsystem
38.8.3.2.1
Configuring the DS3 Interface
For T3 configurations, the Timing Module on the SA-1/RTM rear card controls clock
settings of the individual DS1 trunks only. Timing of the DS3 Interface (high-level
communication protocol on the PSTN Interface) should be configured similar to the
Standalone Board Sync mode.
To configure timing of the DS3 interface:
1.
Click
to access the Media Gateway status screen.
2.
Select the desired Media Gateway board.
3.
In the Navigation pane, select
PSTN
DS3
; the DS3 Interfaces List is displayed.
4.
Select a specific row and then in the configuration pane, click
DS3 Settings
; the
DS3 Setting screen is displayed.
5.
Configure the
DS3 Clock Source
parameter as follows:
•
master
– the clock is taken from the internal board's clock reference.
•
slave
– the clock is taken from the DS3 protocol layer of the PSTN interface.
Summary of Contents for Mediant 8000
