- 83 -
8.
VIDEO TRIGGER DWELL TIME
has feedback
This serial command globally sets the dwell time. Dwell time is the interval that a video input
selection remains on until it switches to the next in sequence. Range is 1-60 seconds.
Code examples
‘SDWELG05<cr>
set dwell time to 5 seconds
‘SDWELG60<cr>
set dwell time to 60 seconds
9.
CYCLE COUNT
has feedback
This global serial command sets the number of cycles all triggers will have when activated. A
cycle is equal to one sweep of any enabled inputs from 1-16 inclusive. range is 1-99
Code examples
‘SCYCLG05<cr>
set to 5 cycles
‘SCYCLG99<cr>
set to 99 cycles
10.
HARDWARE TRIGGER ENABLE / DISABLE
has feedback
This serial command individually enables or disables the hardware trigger control inputs.
Serial commands not affected.
Code examples
‘SHT1SG00<cr>
enable hardware trigger 1
‘SHT2CG00<cr>
disable hardware trigger 2
‘SHT3SG00<cr>
enable hardware trigger 3
‘SHT4CG00<cr>
disable hardware trigger 4
11.
VERSION REQUEST
has feedback
This serial command will give a response with the software version of all video cards
Code example
‘GVERSG00<cr>
get software version number
Response
‘A0VIDV1.1
first card
‘A1VIDV1.1
second card
